Search found 9 matches

by Gav101
Sun Nov 21, 2021 4:59 pm
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Re: Fordson new major - problems

I don't know which site said do not use detergent oils but for diesel engines that is a load of rubbish! This engine should have been run on detergent oils from being new. I think that refers to modern detergent oils, which are quite different from the old SAE 30HD (or 20HD in winter, but that is m...
by Gav101
Fri Nov 19, 2021 7:10 pm
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Re: Fordson new major - problems

Just had to re-write my post, i was going to ask about the fuel filter and compression test too! How long was it parked up, and was it in or outside? If any rainwater gets into a cylinder it can cause the rings to stick, but a compression test would show this up as there would be a low reading on 1...
by Gav101
Fri Nov 19, 2021 7:05 pm
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Re: Fordson new major - problems

I recommend you don't try running until the new fuel filter is on, you have the correct oil in and the fuel tank is clean. Don't forget to clean the sediment bowl on the lift pump either. The transmission (gearbox and rear axle) should have SAE 90 in it, unless you want to use universal SAE 30HD. S...
by Gav101
Fri Nov 19, 2021 7:02 pm
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Re: Fordson new major - problems

<r><QUOTE author="shepp" post_id="59468" time="1637327804" user_id="5428"><s>[quote=shepp post_id=59468 time=1637327804 user_id=5428]</s> The recommended oil for this diesel engine ( any diesel engine ) was from it's introduction in 1951 and always has been an HD30 or HD20 engine oil depending on th...
by Gav101
Fri Nov 19, 2021 10:53 am
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Re: Fordson new major - problems

Castrol Classic 30 is not a detergent oil suitable for diesel engines, it is meant for the early petrol engines pre 1950. Although it can be used in early car gearboxes it will not have the additives and film properties for heavier duty gearbox operations in a Major gearbox or rear axle. You need a...
by Gav101
Fri Nov 19, 2021 10:43 am
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Re: Fordson new major - problems

Hi, Did you measure compression or do you assume you have loss of compression based on the blow by? A bit of smoke from the crankcase vent is not uncommon for little used tractors. This can be some moisture which condensed over time and finds a way out when engine warms up. Personally I wouldn’t fi...
by Gav101
Thu Nov 18, 2021 4:36 pm
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Re: Fordson new major - problems

SAE 30HD is what you want for the engine. Try tightening the high low lever on (unless you have the early type held by a pin, in which case you'll just have to live with it) to see if you can get it to work. You need to do hard ploughing to see if the engine is ok. Sandy Thanks! I've just checked a...
by Gav101
Thu Nov 18, 2021 4:29 pm
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Re: Fordson new major - problems

I wouldn't worry about the bubbles in the gearbox oil, its just from the oil being churned around by the gears. Are the gears any better since you topped up the oil? Thanks that is a relief :D - they do seem a bit less sticky but I haven't had time to use it much since the occasion when it lost com...
by Gav101
Wed Nov 17, 2021 7:12 pm
Forum: Fordson New Major
Topic: Fordson new major - problems
Replies: 20
Views: 8509

Fordson new major - problems

I've owned a E1A 1954 for a couple of years now but am a novice in terms of tractor ownership and maintenance. I used it a fair bit when I first got it and it performed really well other than some gear change issues which I was managing to live with - it would get stuck in a gear after heavy work an...