Page 1 of 1
Steering wheel nut
Posted: Sat May 26, 2012 7:43 pm
by paumass
Hi,
I was wondering if anyone could tell me what size the nut is that holds the steering wheel on. My E1A is missing the nut so im going to have to replace it and the agriline one that ive bought seems to be too small.
Hope someone can help
Paul
Re: Steering wheel nut
Posted: Wed May 30, 2012 11:08 pm
by Timeee
Dear Paumass
Steering wheel retaining nut, according to my parts list is "5/8 inch UNF Blind Nut". Sorry I couldn't reply sooner, I was in France, without my Fordson Major Parts List (a heinous crime, I know!!)
Regards
Tim
Re: Steering wheel nut
Posted: Sat Jun 02, 2012 1:02 pm
by Dandy Dave
The nut I got from Agriline a few years back fit my Power Major Steering wheel. Dandy Dave!
Re: Steering wheel nut
Posted: Thu Jun 07, 2012 9:17 pm
by paumass
Thanks for the replys.
The one that I bought from agriline doesnt fit the steering colum on my 1954 E1A. So im going to bore it out and re tap it.
Re: Steering wheel nut
Posted: Fri Jun 08, 2012 8:21 am
by Nick
Hi there, is it possible the wrong one has been sent out? As I bought a new nut and washer from there, and they fit perfectly.
Re: Steering wheel nut
Posted: Mon Jun 18, 2012 9:50 pm
by paumass
Right iv'e checked the nut with a tap and its deffinately 5/8 unf. But its too small for my steering colum, so any ideas?
Re: Steering wheel nut
Posted: Mon Jun 18, 2012 11:18 pm
by super6954
Hi
I just wondered Have you measured the threads on the colum or tried the 5/8 die on there. I have had them where the first 1 or 2 thread is bad at the start and its been a pig to get the nut to start threading to the point of Thinking it was the wrong nut. I didnt have the die and then had file the threads to get it to fit
. if the nut is missing I wonder if some kind sole tried to get the wheel off and hit the end of the shaft burring it slightly,Then could not get the nut back on and pitched it in the hedge and walked away
.