The Fordson Tractor Pages Forum

Apologies if this is elsewhere on the site, but I am going to drop the top back on tomorrow and need to be sure of setting.

Have used photos from another thread

Am I right in thinking for Qualitrol setting it is 13mm from the stop shown marked in the picture below



And for position it is with the lever right down in the quadrant



Thanks in advance
theseeker905

No. The stop is the little tab in the quadrant at the end of the slot. You have marked the flow control actuator.

Thanks Brian.
for Qualitrol I have set it from the tab
and for position have set it with the lever at the bottom, as the 2nd photo

Thanks for your advice....

Thanks Brian.
for Qualitrol I have set it from the tab
and for position have set it with the lever at the bottom, as the 2nd photo

Thanks for your advice....