Page 1 of 1

Engine running too fast

Posted: Sat Jan 16, 2010 6:17 pm
by damian green
Hi,
I posted a message about the overheating incident followed by poor starting, it did turn out to be the head. Now replaced I have a small problem the engine is reving very fast moving the throttle will speed it up but not slow it. it shuts off fine on pull stop, could this be the idle speed set wrongly or the fuel pump govenor ....... ?

Posted: Sat Jan 16, 2010 8:51 pm
by Jan 59
Check the vacuumpipe from inlet manifold to governor housing.
May be false connection .
Or it can be a leak in the governor diphragm

Posted: Sat Jan 16, 2010 9:11 pm
by damian green
thanks its going to be my first job tomorrow morning the wife will have to wait for her breakfast (Sunday treat lucky girl).
Cheers
Damian

Posted: Sat Jan 16, 2010 11:01 pm
by Brian
If you have a vacuum governed pump it could also be the pump diaphragm.