Page 1 of 1
Piping from manifold to fual tap!
Posted: Thu May 13, 2010 10:57 pm
by JAV9411
I have a complete new piping from the manufold to fual tap, this is include nuts. Do old one has the previous owner put away. Now I must bend the new one but what is the best way to it it and where is the piping fittend, can someone help for the good way mounting?
Posted: Sat May 15, 2010 7:55 am
by Dunggatherer
The best way to bend the tube would be with a tubebender.
But if you are careful you may get away with bending it with your hands around a wooden stick or so.
On the one side it is connected to the fuel primer,under the tank.
It runs underneath the tank then,to the right side.
Then with a few curves upwards to the manifold.
On the "home" page you see a tab "Dexta".
There you find a Parts list.
One of the drawings shows the fuel system,with that pipe.
Good luck.
Rob.