Super major rear crank seal

liam · Post by **liam** » Wed Nov 03, 2010 12:20 am

Hi,
I have a super major that is leaking at the rear crank seal and I hope to replace it in the next few days.
My question is does the new modern rope seals have to be soaked in oil first before fitting?
When I do fit it, how much of the seal do I leave protruding before assembly.
Thanks in advance.

Post by **Brian** » Wed Nov 03, 2010 8:22 am

I would oil it well rather than soak the modern ones. You need to leave about 2mm on each end.

liam · Post by **liam** » Wed Nov 03, 2010 2:01 pm

Thanks for your help Brian .Will hopefully make a start at the weekend .

Supermanuel · Post by **Supermanuel** » Wed Nov 03, 2010 3:35 pm

To change the clutch shaft oil seal at gearbox end is also a good idea.